Installation Sheet

5
LIST OF MATERIALS
Removing the packaging.
I CAUTION
Remove carton carefully, Wear gloves to protect against sharp
edges.
I WARNING
Remove the protective film covering the product before put-
ting into operation.
Supplied Part Pieces Supplied Part Pieces
Hood assembly with blower and
LED lamps already installed
1
Side spacers
2
5x45 mm
4
10” round air transition
1
4x8 mm
10
Parts no supplied
Tools/Materials required
•Level
•Drill
•1¼”(3cm)drillbit
•⅛”(3mm)drillbit
•Pencil
•Wirestripperorknife
•Tapemeasureorruler
•Pliers
•Caulkinggunandweatherproofcaulkingcompound
•Ventclamps
•Jigsaworkeyholesaw
•Flat-bladescrewdriver
•Metalsnips
•Phillipsscrewdriver
Ducting Options
Closely follow the instructions set out in this manual. All res-
ponsability, for any eventual inconveniences, damages or fires
caused by not complying with the instructions in this manual,
is declined.
Preparation
Do not cut a joist or stud unless absolutely necessary. If a joist
or stud must be cut, then a supporting frame must be
constructed.
Fittings material is provided to secure the hood to most types
of walls/ceilings.
However, a qualified technician must verify suitability of the
materials in accordance with the type of wall/ceiling.
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent.
The hood is equipped with an 10” (25.4 cm) round transition
for discharge of fumes to the outside.
Roof Venting Wall Venting
A
B
B
C
A
G. 10” (25.4 cm) round vent
H. Wall cap
A. Wall cap
B. 10” (25.4 cm) round vent
C. 90º elbow