Installation Instructions

11
Controls
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in operation
during cooking and for another 15 minutes approximately after
terminating cooking.
Description of control panel
Control Panel
1. Button ON/OFF light
2. Button ON/OFF Timer: delayed switch-off of the selected
suction speed (power):
Suction speed (power) 1: 20 minutes
Suction speed (power) 2: 15 minutes
Suction speed (power) 3: 10 minutes
Intensive suction speed (power): 5 minutes
3. Button OFF / Decrease of suction speed (power)
4. Button ON / Increase of suction speed (power)
5. Display, showing:
a. Suction speed (power): LEDs L1 – L2 – L3 - L4 (flashing)
light up according to the selected suction speed (power).
Note: the L4 LED – intensive suction speed (power) works
for about 5 minutes, then the hood sets the intermediate
speed.
b. Timer: the LED of the selected speed flashes to indicate that
the timer is active.
c. Grease filter saturation: the L3 and L4 LEDs flash
alternately
at short intervals of time.
d. Activated charcoal filter saturation: the L3 and L4 LEDs
flash simultaneously
at short intervals of time.
Reset of the filter saturation indicator: perform filter
maintenance, then press button 2 until the LEDs turn off.
Note: The activated charcoal filter saturation is normally disabled
and is enabled only if the hood is used in the filtering version (with
charcoal filter installed).
In order to activate it, proceed as follows:
- Switch off the hood
- Keep pressed simultaneously buttons 3 and 4, until the LEDs
L1 and L2 flash briefly.
Repeat the operation to disable; only LED L1 flashes briefly.