LI3E7C Ed.
EN - Instruction on mounting and use 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. Consult the designs in the front pages referenced in the text by alphabet letters. Closely follow the instructions set out in this manual.
Mounting Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, grout or silicone this appliance to the wall. Surface mounting only. Description of the hood - Fig. 1 H. Interconnection cable K. Control lever Attention! The control lever is already supplied.
Reset grease filter saturation signal (FLASHING GREEN LIGHT on control panel) First proceed with filter maintenance as described in corresponding paragraph. Press and hold down (for more than 3 seconds) the T1 button on the control panel, the LED light will stop flashing indicating that the signal reset has been carried out, the hood will switch off. Reset coal filter saturation signal (FLASHING ORANGE (amber) LED light) First proceed with filter maintenance as described in corresponding paragraph.
Maintenance of the remote control Cleaning the remote control: Clean the remote control with a damp cloth and a neutral solution of detergent without abrasive substances. Changing the battery: • Open the battery casing using a small screwdriver with a flat point. • Change the finished battery with a new one of 12 V type MN21/23 In inserting the new battery respect the polarity indicated on the battery casing! • Close the battery casing up again.
