Installation Guide

Aiandi 13/1 | Tallinn 12918 | Estonia
Tel: [phone] | [e-mail] | www.eliko.ee
16
8. CLIENT SOFTWARE INTEGRATION
The Eliko RTLS Server communicates with
external parties via TCP ports. It can act
both as a TCP server or a client. The Eliko
RTLS Server is always listening for incoming
TCP connection requests on port 25025. You
can use the Eliko RTLS Server’s IP address
and port 25025 to create a connection to
the Eliko RTLS Server from your own appli-
cation. You can then congure the Eliko
RTLS from your own application, as well as
to get live positioning data. Alternatively,
the Eliko RTLS Server can instead act as a
TCP client and connect to your server. For
that, go to the “System/General Settings”
tab on the Eliko RTLS Manager and select
the IP address and TCP port your server is
listening from.
Additional instructions on how to integrate
the Eliko RTLS to your own application can
be found under the “System/Documenta-
tion” tab in the Eliko RTLS Manager.
9. TURNING OFF THE SYSTEM
Do not unplug the server directly from the
mains power because it can possibly corrupt
the le system. To power down, use the on/
off button on the server. After the server
power indicator light has turned off, it is
safe to unplug the devices.
NOTICE:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTICE:
Changes or modications made to this equipment not expressly approved by Eliko may
void the FCC authorization to operate this equipment.
NOTICE:
The range of the devices may be negatively affected by devices operating at the same
wavelenght.
NOTICE:
According to FCC rules, the anchors may only be operated indoors. Operation outdoors
is in violation of 47 U.S.C. 301 and could subject the operator to serious legal penal-
ties.