Manual

Electro 56 LED

SPECIFICATIONS:

Model: Electro 56 LED

LED’s: 108 (36 Red, 36 Green,

and 36 Blue)

Weight: 3.85lbs./ 1.75kgs.

Size: 6.88” (H) x 8.26” (W) x

8.6” (D)

Fuse: 1 Amp

Supply Voltage: 90v/240v ~ 60Hz/50Hz

Working Position: Any Safe position

Duty Cycle: None

DMX Channels: 4

Colors: Multiple Colors

Warranty: 1 Year

CAUTION! Please read and

understand these instructions

before installing or operating

this unit.

Operating Instructions:

The Electro 56 LED has been tested at the factory, there is no assembly required. The unit is ready

to be plugged into a power outlet. This unit is a 4 channel DMX intelligent LED par can. It can be run

as a stand-alone unit, DMX controlled unit, or in a Master/Slave configuration. While in Stand Alone

or a Master/Slave configuration, you can run the auto mode, sound active mode, or control the col-

ors manually. For stand-alone mode, Master/Slave configuration, and DMX Control see other side.

Caution! Never open unit when in use.

Always disconnect main power before

replacing fuse. Remember to always

replace with the exact same type fuse.

1 Year Limited Warranty: Eliminator Lighting warranty is valid from the date of purchase. Our

1 year limited warranty covers manufacturing defects only. Serial number, place of purchase with

dated valid receipt must be submitted at time of service. Eliminator Lighting warranty does not cover

items or parts prone to wear and tear: lamps, leds, fuses, brushes and belts. Eliminator Lighting war-

ranty is only valid with-in the United States.

PAGE 1
SPECIFICATIONS: Electro 56 LED CAUTION! Please read and understand these instructions before installing or operating this unit. Model: LED’s: Weight: Size: Fuse: Supply Voltage: Working Position: Duty Cycle: DMX Channels: Colors: Warranty: Electro 56 LED 108 (36 Red, 36 Green, and 36 Blue) 3.85lbs./ 1.75kgs. 6.88” (H) x 8.26” (W) x 8.6” (D) 1 Amp 90v/240v ~ 60Hz/50Hz Any Safe position None 4 Multiple Colors 1 Year Caution! Never open unit when in use.
PAGE 2
Stand Alone (Manual Mode with Strobe): 1. Plug the fixture in, dipswitch controls are as follows: dipswitch 1 is Red, dipswitch 2 is Green, and dipswitch 3 is Blue. 2. Use dipswitches 4-6 to control the speed of the strobe. Stand Alone (Auto Mode): 1. Plug the fixture in, and put all dipswitches in the “Off” position. Use dipswitches 7 & 8 to control the color fade speed. Stand Alone (Sound Active Mode): 1. Put dipswitch 9 in the “On” postion.