Use and Care Manual

DMX Mode:
Operating through a DMX controller gives the user the freedom to create their own programs tailored
to their own individual needs. The Trio Par LED RG has 4 DMX channel modes; 6/10/26/30 channels.
See the chart below for the DMX traits and values.
1. This function will allow you to control each individual fixture’s traits with a standard DMX 512
controller.
2. To run your fixture in DMX mode plug the fixture in and press the MENU or UP and DOWN
buttons until “Addr” is displayed and press ENTER. “A.XXX” will now be displayed. “XXX”
represents the current displayed address. Use the UP or DOWN buttons to select your desired
DMX address.
3. Press ENTER again to select your desired DMX channel mode. Use the UP and DOWN buttons
to find your desired DMX channel mode.
4. After you have chosen your desired DMX address and DMX channel mode, press ENTER and
plug in the fixture via the XLR connections to any standard DMX controller.
Jump Change Mode:
1. Plug the fixture in and press the MENU or UP and DOWN buttons until “ASC -” is displayed.
2. Press the ENTER button to adjust the Jump speed. Use the UP and DOWN buttons to adjust the
speed. The speed can be adjusted between “AS.00” (slowest) to “AS.12” (fastest).
3. After you have adjusted the program speed you can activate strobing by pressing the MENU
button until “FLAS” is displayed and press ENTER. The Flash can be adjusted between “FL.00”
(flash off) to “FL.12” (fastest flash).
©Eliminator® Los Angeles, CA. - www.EliminatorLighting.com
Menu Submenu Channels Operating Mode
Addr A.001-512 6/10/26/30-Ch DMX address/channel
mode
ASC- AS.00-12 Jump change
mode/speed
ACC- AC.00-12 Pulse change
mode/speed
FAde FA.00-12 Fade
change/speed
SOUF SF.00-12 Pulse change sound
control/sensitiveness
rL-- rL.00-12 Red brightness
adjustable
gL-- gL.00-12 green brightness
adjustable
bL-- bL.00-12 Blue brightness
adjustable
uL-- uL.00-12 white brightness
adjustable
L1-- ON/OFF Laser R on-o
L2-- ON/OFF Laser G on-o
FLAS FL.00-12 Strobe speed