Use Instructions

Fig. 1
3.5mm SYNC
socket
Operating Instructions
1. Connect the SYNC cable to the EL-Skyport SYNC socket and the ash unit SYNC socket.
Use included SYNC cable.
2. Check the correct Group and Channel setting for the Transmitter and
Universal Receiver.
3. Switch ON the EL-Skyport Universal Receiver and Transmitter
4. Switch ash unit ON and press “TEST” push button on EL-Skyport Transmitter for a Test
ash.
Operating Modes
1. Battery mode: Charge LED ashes when switched ON. If not used for 4 hours, the unit
will switch to Stand-By Mode (switch Receiver OFF and ON to return to normal mode)
2. Supply mode: With Wall-Adapter Charger plugged in for long term xed operation
Note:
If the EL-Skyport Receiver is used whilst charging (in Supply Mode), the Universal Receiver
will not change to Stand-By mode.
Frequency
channel selector
Flexible swivel
Antenna 360 
Charge socket for
EL-Skyport Wall Charger only
GROUP switch
ON/OFF switch
Status LED (green)
Frequency Channel
Note:
Transmitter and the corresponding RX Transceivers or Universal Receivers must have
the same frequency channel setting !
Frequency
Channel
Slide Button conguration
Trigger
Frequency
/ Mhz
Remote
Frequency
/ Mhz
1 2 3
1 (default) Off Off Off 2456 2448
2 On Off Off 2458 2450
3 Off On Off 2460 2452
4 On On Off 2462 2454
5 Off Off On 2469 2461
6 On Off On 2471 2463
7 Off On On 2473 2465
8 On On On 2475 2467
Note:
After changing the frequency, switch Receiver OFF and ON again to activate the new settings.
Trigger Group Settings
The EL-Skyport Transmitter triggers the Universal Receiver in following modes:
1. Groups(1 to 4) sets and triggers ash units in different “Groups”
 è only Flash Units with the selected Group are triggerd by the Transmitter
(Group setting must correspond between Transmitter and Receiver)
2. ALL
Transmitter is set to ALL
 è The Transmitter triggers all EL-Skyport Receivers
4
5