Specifications
PocketWizard Utility
Some settings require the PocketWizard Utility software and your ControlTL
radio connected to a computer via the Mini-USB port. Download the Utility at
www.PocketWizard.com/support
PowerST4 Receiver Utility settings:
Channel Tab
Set your receive channel to match your transmitter. If you are using a MiniTT1 or FlexTT5 as your transmitter,
make sure Use ControlTL for Receive Channel is checked. If you are using a Standard transmitter like the Plus II
or MultiMAX, uncheck this box. Default = ControlTL 1
Exposure Tab
Flash Exposure Compensation (FEC): Offsets exposure for the connected ash only. This setting can be used
as a simple FEC control for an individual ash, or it can be used to set ashes on the same zone to different power
outputs or to balance them. For example, you could use -1.0 to make a 600RX match the power of a 300RX. This
setting is cumulative with other FEC values set in the system. This control can also be used to adjust where the
PowerTracking center point aligns with your camera’s FEC control. See the FEC NOTE and CAMERA FEC RANGE
section for more information. Default = 0.0
Flash Tab
Flash Idle Time Out Mode/Delay: The modeling light will turn off after the set time if no triggers are received.
Uncheck the box to have the modeling light stay on. Default = Enabled at 600 seconds (10 minutes)
IMPORTANT: Make sure to press the Set Conguration button to save your settings.