AN2 Series 900tvl CMOS Technology High Resolution Sensor P/N 01.BSM.16.2000030 V1.0 Product Made in China under ISO9001 & ISO1400 standards Manual Printed in China v1.0 eLineTechnology.
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning with an arrowhead symbol, within an equilateral triangle is intended to alert the users to the presence of un-insulated “dangerous voltage” within the product’s enclosure that may be sufficient magnitude to constitute a risk of electric shock to persons.
Identification Installation Mechanical Drawing Installation information (General overview) 62 mm 2 3/8 in 194 mm 7 5/8 in 1 2 Locking Screw 226 mm 8 7/8 in 4 77 mm 3 in 3 Rotation lock 5 Accessories 1 2 (A) Wall Plugs (B) Fitting Screws S7 x 26mm 3pcs PA4 x 24mm 3pcs (C) L-Hex tool 54x18mm 3 4 (D ) Drill template NOTE: Make sure you don’t have any missing parts before you make the installation. Incorrect installation could void the warranty if instructions are not followed correctly.
Identification Installation Mechanical Drawing Installation information (General overview) 99 mm 3 7/8 in 1/2” 1 2 3 4 5 6 118 mm 4 5/8 in 117.5 mm 4 5/8 in Vari-Focal Lens Model 152 mm 6 in Accessories (A) Wall Plugs (B) Fitting Screws S7 x 26mm 3pcs PA4 x 24mm 3pcs (C) L-Hex tool 58x20mm (D ) Drill template NOTE: Make sure you don’t have any missing parts before you make the installation. Incorrect installation could void the warranty if instructions are not followed correctly.
CAMERA ADJUSTMENT (option) The OSD control may differ from show above, OSD buttons may replace the joystick type. Service cable output maybe not be available, and maybe optionally supplied with the product.
TROUBLE SHOOTING NOTES Follow the steps below if you are experiencing trouble with your camera, before you contact your Technical Support. • Nothing appears on the screen. ¤¤ Check that the power cable is connected properly and that the voltage is correct. ¤¤ Check that you have properly connected VIDEO cable to the camera VIDEO output jack and to the monitor/DVR. • The image on the screen is unclear. ¤¤ Is the lens or dome cover stained with dirt? Clean lens or dome cover with soft, clean cloth.
