User guide

CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning with an arrowhead symbol, within an equilateral triangle
is intended to alert the users to the presence of un-insulated
“dangerous voltage” within the product’s enclosure that may be
sufcient magnitude to constitute a risk of electric shock to persons.
The exclamation point with an equilateral triangle is intended to alert
the user to the presence of important operating and maintenance
(servicing) instructions in the literature accompanying the appliance.
This equipment has been tested and found to comply with limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy, if not
installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the
interference at his own expense.
Changes or modications not expressly approved by the manufacturer
could void the user’s authority to operate the equipment.
To prevent electric shock and risk of re hazards:
• Do NOT use power sources other than that specied.
• Do NOT expose this appliance to rain or moisture.
This installation should be made by a qualied service
person and should conform to all local codes.
1 2
Guide
Solution General Specications
General
Power source Regulated 12VDC
Power Consumption 100mA IR LED
IR LED On Power 10pcs Max 275mA 15pcs Max 320mA
Scanning system Progressive Scan Sensor
Scanning frequency NTSC 15.734KHz( H), 59.95Hz (V) / PAL 15.625KHz (H), 50Hz (V)
Effective Pixels 1305(h) x 1049(V)
Resolution 900TVL
OSD Control Optional Control via cable (see OSD Menu Page 7-8)
ACG / BLC On
Noise Reduction 2d/ 3d Enabled
Sync System Internal
Min. Illumination 0.01 Lux (AGC On, IE Off) / 0 Lux with IR LED On
Video output 1.0 Vp-p (75Ω , composite)
S/N Ratio More than 52dB (AGC OFF)
Video output BNC Connector 1.0Vp-p PAL / NTSC
Lens mount Fixed mount
Lens Matching for each model.
Operating temperature -10°C ~ +50°C / -40°F ~ 122°F
Operating humidity 0-90% (non-condensing)
Model Features:
• 1/3” CMOS Sensor
• 900TVL Sensor imaging
• Day/Night / ICR
• Programming via OSD
• BNC Video Output
• Standard 12VDC Operation lower power
• Super ux IR LED for night vision
• 3D Noise reduction
*Specicaons subjected to change without prior noce.