Instruction Manual

15
Installation
English
4.4 FLUSH MOUNTING (INDOOR ONLY)
Camera is not weatherproof if installed using this method.
Use the included wall mount or accessory ceiling mount for
outdoor installations.
Make sure to disconnect power before installing the camera.
Camera will begin moving immediately when power is connected.
1. You must remove the camera from the included wall mount for indoor
flush mounting. To do so:
• Rotate the dome cover counterclockwise to remove.
• Remove the base attachment screws (3x) and remove the camera
fr
om the camera base.
• Remove the camera base by removing the camera attachment screws
inside the wall mount (4x).
• Disconnect the video and alarm cables from the camera.
1
2. If necessary, change the camera’s ID and protocol information. See
“Changing Protocol Information” on page 5.
eLineTechnology.com