Owner manual

18
Alarm configuration: in the alarm configuration interface can check the alarm
way: audible alarm, trigger alarm and e-mail alarm
Trigger recording: check the trigger channel at "trigger video" interface, . Click
"OK" to save the above settings, click "Exit" to exit the current interface channel.
Alarm linkage: set the alarm type and linkage type at linkage alarm interface, such
as preset positions, cruise line or track (Note: these three is already applicable in
before PTZ configuration, click "OK" to save above settings when the corresponding
channel alarm input, PTZ start a preset point,cruise lines and trajectories. Click "Exit" to
exit the current interface.
Pic 2-20 Alarm handling - alarm linkage
User can setup all channels with same parameters, please tick off “All”, and then to do
relevant setup.。
Click “Default” button to resort default setting; click “Apply” button to save the setting;
click “Exit” button to exit current interface.
2.4.5.2 Motion
Motion includes one sub menus: motion
1> Motion
Pic 2-21 Motion
Click start motion alarm and set alarm hold time，It refers to after close motion alarm it
delay to the preset setting time. Click alarm "Settings" button, show below window：
eLineTechnology.com