User guide
25 26
Configuration
•
Frame
Rate:
Select the frame rate for the stream up to maximum of
30FPS
for stream1 or stream2 or
12FPS
for stream3.
NOTE:
Frame rate ma
y
be a
utoma
t
ical
l
y
adjusted
to
ac
c
o
un
t
f
o
r
bandwidth
limitations.
•
I Frame interval: Select the interval for I frames: 1, 2, or 3.
The
default
value of 2 should be used unless there are special requirements.
The
I
Frame interval
does
not apply to stream3.
•
Bit Rate:
For stream1 or stream2, select
CBR
(Constant
Bit
Rate)
or VBR
(Variable
Bit
Rate).
Enter the desired bit rate below in
kbps.
Stream3 only
supports VBR.
•
Quality:
Select the
video
quality between 1 (lowest) and 9 (highest).
TIP:
A quality of 7 provides a
good
picture. It is not recommended to set a
high quality value with a small
VBR
bit rate.
3. Click
OK
to apply changes.
6.7
Device
Configuration
Device
Configuration contains the following sub-menus:
•
Local Network
•
Device
Port
•
Camera
•
Date & Time
•
OSD
•
Microphone
•
BNC Video
Output
•
Language
•
Multicast (Not supported)
•
Dome
PTZ
(Not supported)
Configuration
6.7.1 Local
Network
The
Local Network
page
shows the camera’s current IP address and
network parameters if
DHCP
is enabled. It also allows you to set a static IP
address for the camera
(see
below), set the networking parameters, and to
select
IPv4
or IPv6.
NOTE:
DHCP
is dis
abled by
default.
When DHCP
is
enabled,
the
IP
address
is shown under
DHCP
IP.
Use the IPScan tool on CD
to configure a static
IP address. This
will
prevent the camera IP address changing in the event
of a power
f
a
ilur
e.
To configure
the
camera’s networking
parameters:
1. Click
Device
Configuration>Local
Network.
2. Under IP
Protocol
,
select
IPv4
or
IPv6
.
If
you
would like to use
IPv6,
mak
e
sure it is supported on your network.
You
may need to contact
y
o
ur
network administrator or
ISP
for
details.
3. Select
Device obtain an
IP
address automatically
to use
DHCP
or Device
use
the
following
IP
address
to set a static IP address
for
the camera.
If
you are using a static IP address, configure the
f
o
ll
owing:
•
IP
Address:
Enter the IP address
you
would like to assign to the camera.
Make sure the IP address is available on your network.
•
Subnet Mask:
Enter the subnet mask.
•
Preferred
DNS
Server/Alternate
DNS
Server: Enter desired DNS
servers.
eLineTechnology