User guide

35 36
Configuration
3. Click
Schedule to configure a motion detection schedule. The Schedule
Time Setting menu opens.
NOTE: If the Schedule Time Setting does not open, disable any popup
bl ock er s.
4. Configure the weekly schedule. The schedule is divided into 3 periods,
and motion detection will be enabled in all times during all 3 periods.
5. Click
Motion Area, and configure up to 8 motion detection areas:
• Select Area Motion or Area Mask to configure motion detection areas.
• Area Motion allows you to select areas where motion detection is enabled.
• Area Mask enables the entire image for motion detection, and allows you
to select areas to disable motion detection.
• Right-click to delete the last created area.
6. Under
Sensitivity , select the sensitivity for motion detection: Low,
Medium , or High.
7. Click
OK to save your settings.
Configuration
6.9 Local Record
Local Record contains the following sub-menus:
• Record Policy
• Record Directory
6.9.1 Record Directory
Record Directory allows you to configure the microSD/SD memory card,
NAS, and FTP storage locations. It also allows you format the microSD/SD
card.
IMPORTANT: You must format the microSD/SD card using the camera
before you can record to
it.
To format the microSD/SD card to enable recording:
NOTE: Formatting the microSD/SD card erases all data on the c a r d .
1. Click
Local Record>Record Directory.
2. Make sure to disable all recording types in
Reco r d Policy bef o r e
formatting the microSD/SD
c a r d . See “6.9.2 Record Policy” on page 41.
3. Under
Disk Name , select SD1.
eLineTechnology