User guide

1 2
1. GETTING STARTED
The system comes with the following
components:
• 1 x Camera
• 1 x Mounting Screw Kit
• 1 x Allen Key
• 1 x RJ45 Coupler
• 1 x BNC Test Cable
• 1 x Mounting Template
• 1 x Quick Start Guide
• 1 x Instruction Manual
• 1 x Software/Documentation CD
Mounting Screw Kit:
• 4 x mounting screws
(PA4 30mm)
• 4 x drywall anchors
Allen Key
RJ45 Coupler
BNC Test Cable
1.1 Default Camera Username, Password, and Ports
Username: admin
Password: admin
Ports: 80
(HTTP), 30001 (Control/Streaming), 8080 (RTMP), 554 (RTSP)
IP Address:
DHCP Enabled by Default (Router will automatically assign IP
address)
NOTE: Once you have completed the basic setup of the camera, it is
r e c o mmended t o configure a static IP addr es s. This will pr ev ent the c a mer a
IP address changing in the event of a power failure. For details, see “6.7.1
Local Network” on page 26.
1.2 Camera Interior Overview
Access panel. With Micro sd Card slot*. Status LED, camera reset & service
video
*microSD card slot (max. 64GB supported; SanDisk™/Kingston™ brand
memory cards
1.2.1 Functions of Status LED’s
• POWER (Top): Glows green when camera is connected to power.
• NET (Middle): Flashes red to indicate network activity. recommended)
CdS Light sensor
Lens Zoom
& focus adjust
eLineTechnology