User's Manual

total scores will be displayed at the end of the time. Press button D on the remote to start a
new round.
F-3, Counts shooting, within the preset counts, broadcasting every effective shooting and
total scores will be displayed at the end of the counts. Press button D on the remote to start a
new round.
F-4, Respond shooting, the shooting hint (three bees) will be randomly provided within
every 10 seconds count down, pulling out the gun and shot when the hint arises, the score and
respond time will be circularly displayed on the screen. If there was no effective shooting
detected within 60 seconds, digits 60 and 0 will continuously flash on the screen. Press button
D on the remote to start a new round.
4.4.2 Self-checking mode:
4.4.2.1 Battery power level
The battery power level will be reflected by voltage: when the battery voltage is ≤3.5V,
the board enters low power mode and LED screen will display ‘LO’ to remind the user to
charge the battery. No further operation is allowed just switch off the power and recharge to
battery to 3.5v-4.3v, then it can be operated.
Under the game mode, long press the A button on the remote to enter power level
displaying mode and press A again to return to game mode.
4.4.2.2 PT array detection (only for engineering test) mode:
Circularly detect the corresponding PT of 1-5 controller: the LED screen will indicate “1.
00” when entering this mode, using a big diameter light plate to illuminate the board (PT array),
the “00” will change from 1-30. Among those five controllers, number 1-4 has 30 corresponding
PT each and number 5 has 27 instead.
For example:
1. 00: 1. Means number controller
00 means the functional corresponding PT of number one
controller.
4.5 Remoter button definition
A: Function switching
Under the game mode: short press this button to select from F-1. F-2. F-3. F-4. Long
press this button to enter battery power level mode (indicating the current battery voltage)
Under the PT detection mode: short press this button to select from 1.00, 2.00, 3.00,
4.00, 5.00 which will be displayed on the LED screen.
B: +
Short press: number increasing under F-2 and F-3 mode.
Long press: Speaker volume increasing
C: -
Short press: number decreasing under F-2 and F-3 mode.
Long press: Speaker volume decreasing
D: Confirmation
Short press:
F-1 selected and flashes, the board will start work after one effective shooting is