Use and Care Manual

BEFORE USING YOUR BLENDER

1. Take the appliance and its accessories out of the packaging materials.

2. Thoroughly wash all parts intended for contact with food (large and small blending

jars, caps and the blade assembly), using warm water and a neutral kitchen

detergent. Then rinse with clean water and allow these parts to dry naturally or dry

them out thoroughly using a wiping cloth. All removable parts can also be safely

washed in the top rack of a dishwasher.

ATTENTION:

When cleaning the blade assembly, take special care to avoid injury. The

blades are sharp. The blade assembly has a gasket seal to ensure that the blending jar

remains air-tight during the blending process. If the blade assembly is washed in a

dishwasher, this gasket seal may come loose due to heat. After washing the blade

assembly, always check that the gasket sea is in its place.

ASSEMBLING AND DISASSEMBLING THE APPLIANCE

Before you start assembling or disassembling the appliance, check that the motor unit is

turned off and disconnected from the power socket and that the rotating parts have

come to a complete stop.

ASSEMBLING AND DISASSEMBLING THE BLENDER JAR

1. Turn the blending jar over so that the neck points upwards.

2. Check that the gasket seal on the blade assembly is in its place. Place the blade

assembly on to the neck of the blending jar so that the blades point inwards and

screw it clockwise on to the neck of the blending jar.

NOTE:

Place the ingredients into the blending jar before attaching it to the blade

assembly. When filling the blending jar do not exceed the MAX mark.

3. Turn the assembled blending jar over so that the blade assembly points downwards

and insert it into the motor unit so that the tabs along the outer perimeter of the

blending bottle slide into the slots on the motor unit.

4. To disassemble, proceed in the reverse sequence.

Assembly

Disassembly

Questions? We're here to help! Visit: www.maxi-matic.com for support on this product.