User's Guide

ManualsBrandsElite Screens Visual & Sound ManualsElectronicsElite Screens

Slide

switches

Default

“000”

IR Lens

Led Indicator

light

Stop

Down

Led

Indicator light

Stop

Down

Logo

FBZZ-RC1Z003-01

Note: IR remote operation requires a

clear line of sight. Assure the IR receiver

is not obstructed.

When operating the screen with the IR

remote, point the “IR Lens/IR LED”

directly to the screen’s “IR receiver”.

ZRC1-IR

IR remote control

ZRC1-RF

RF remote controller

User’s Guide | Infrared (IR), Radio Frequency (RF) and Wall-box controls

Slide switches for RF Code Change

(when multiple RF remotes are owned)

How to change the RF code

1. Remove the batteries

2. Change switch,

3. Insert the batteries

4. Synchronize it with the wall box

(Refer to the Wall-box controller guide for pairing.)

Battery compartment

Requires AAA x 2

(not included)

3.5mm Projector

Trigger Port

Summary of content (3 pages)

PAGE 1
User’s Guide | Infrared (IR), Radio Frequency (RF) and Wall-box controls ZRC1-IR IR remote control ZRC1-RF RF remote controller IR Lens Led Indicator light Led Indicator light Up Up Stop Stop Down Slide switches Down Logo Logo Default “000” Note: IR remote operation requires a clear line of sight. Assure the IR receiver is not obstructed. When operating the screen with the IR remote, point the “IR Lens/IR LED” directly to the screen’s “IR receiver”. FBZZ-RC1Z003-01 3.
PAGE 2
User’s Guide | Infrared (IR), Radio Frequency (RF) and Wall-box controls FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
PAGE 3
ZRC1-WB Wall-box controller Led Indicator light RJ50: Connects to the Screen IR Receiving Window 3.5mm Projector Trigger Port Stop Up Down Programming Key Logo Programming Key Instructions: 1. How to Preset the Screen’s Drop Position: Drop the screen to the desired position you want to set it at. Press & hold the “Programming Key”, then press the “down key”. 2. Clear/Reset the Screen’s Drop Position: Press & Hold the “Programming Key”, then press the “stop key”. 3.