Manual Pull-Down Screen Elite Manual Series USER’S GUIDE Rev. 1.3 www.elitescreens.com / eliteinfo@elitescreens.
MATTE WHITE Pre-installation 1. Carefully unpack the screen 2. Always handle the screen on a clean and level surface. OPTIONAL ACCESSORIES: L-Brackets and Mounting Screws. a: Vertical hooks suspend the screen from the L-bracket wall mounts” They are secured in place with a nut. (c) b: Wall-screw secures the L- bracket to either drywall or wall-studs. c: Nut secures the end of the vertical hook (a) and holds it into place. d: D-bolts allow the option to mount the L-bracket to concrete walls.
Installation Flush Wall Mounting 1. Using a tape measure, mark the keyholes that are located at the back of the screen’s case end cap. 2. After marking the area and predrilled hole, insert the screw and leave the screw’s head out about 4mm (1/8”) from the wall to mount the screen on. (Fig. 1) Fig. 1 Ceiling Mounted (additional hardware required) Optional installation using a chain to hang the screen from the ceiling. Loops Fig. 2 2.
Optional “L” Bracket diagram 1” Width 6-3/4” Length 6 3/4” Height Find the studs on your wall or use drywall anchors to install L brackets to the desired location. Top of “L” bracket from top view “L” Bracket accessories Wood/Dry Wall installation: Use “B” wood screws provided for installation on wood studs on wall. Or use “E” hollow wall anchors provided in conjunction with the wood screws for dry wall installation as shown on Fig. 3. Fig.
SCREEN OPERATION Note: Always pull the screen down or let it up in either a steep incline or a 90-degree vertical angle. Do not allow the screen to touch the screen case when the screen goes up or comes down to avoid damaging the screen material. Fig. 5 1. Pull the screen down with the lanyard or by the handle at either a sharp incline or in a 90degree angle. Do not attempt to pull the screen down by its material or touch the screen, as it will cause damage and likely void the warranty. (Fig.
Maintenance Clean matte white screen material with a soft cloth and mild soap with water. When not in use, retract screen in its housing to keep the surface clean. NOTE: Regardless of mounting method, the screen should be securely supported so that vibration or even abusive pulling on the viewing surface will not cause the case to work loose or fall. The installer must insure that the fasteners used are of adequate strength and suitable for the mounting surface chosen.
TWO WAY TO REGISTER YOUR WARRANTY WITH ELITE SCREENS INC. A. On Line (Faster and Easier) www.elitescreens.com/register.html B. Fill out & Fax to (562) 483-8498, Attn: Customer Service Dept.