User Guide

www.elitescreens.co
m
/
eliteinfo
@
elitescreens.com
Rev. 1.3
Installation
Flush Wall Mounting
1. Using a tape measure, mark the keyholes that are located at the back of the screen’s case
end cap. 2. After marking the area and predrilled hole, insert the screw and leave the
screw’s head out about 4mm (1/8”) from the wall to mount the screen on. (Fig. 1)
Fig. 1
Ceiling Mounted (additional hardware required)
Optional installation using a chain to hang the screen from the ceiling.
Fig. 2
2. You can also hang the screen on a ceiling by using a chain with s-hooks (not included)
through the two loops located on each end of the case as shown on (Fig. 2).
Loops