Owner Manual

110315-JA www.elitescreens.com 8
Edge trim Installation
Included is an black edge trim that provides an elegant ultra-thin bezel finish
1. Place the assembled frame on a flat and clean surface. The projection screen surface should be facing up. Align the
tape with the edge of the screen, as shown in Figure 1. Once properly aligned, apply the black tape to the center of
the top and bottom of the screen material.
Figure 1
2．Without removing the adhesive tape, place all the trim pieces along the edge of screen material. Adjust the trim
pieces so that the four corners are evenly aligned. (Note: The Elite logo should be positioned on the bottom right).
Refer to Figure 2 below for a visual reference.
Figure 2
NOTE: Make sure the bottom edge trim with the Elite Screens logo is installed on the correct side. The back of the
material should be labeled with a DOWN sticker to indicate the material is facing in the down position. The Elite
Screens logo should be installed on the DOWN side
Plastic corner sleeve x4pcs
Edge trim x 6 PCS
Black tape x1pcs
Trim
strip
Screen Material
The black tape
The black tape
Front Side
Back Side