User Guide

Rev.081914-JA www.elitescreens.com 4

Attaching the screen material to the frame

1. Make sure the screen material and frame are both lying face down on a clean, dry, and non-abrasive surface.

2. Carefully unroll the material inside the frame. (Fig.3)

Please note the material will be noticeably smaller than the frame, as the material must be stretched to create a

sufficient amount of tension for perfect material flatness.

3. Attach the fix plates.

(1)

Stretch the material to the corner and insert the screen material’s edge in the groove of the frame. While

one hand holds the material in place the other hand snaps in the push plate (Fig.4-Fig.5).

(2) Begin by securing the four corners in the following sequence A→B→C→D (Fig.6).

(3) Insert the fix the plates as shown on Fig. 5. Fix plate ① is about 10cm away from the frame’s corner.

Fix plate ② is about 5cm away. (Fig.7)

(Fig. 6)

(Fig. 7)

Notes：



Make note of the label to help distinguish

the back and front side.

 Unroll the screen material face down



Keep the screen material as close as

possible to the frame and do not allow it to

scratch against any part of the frame.

(Fig. 4)

Insert push plate in

Screen material edge

(Fig. 5)

Schematic cross section

of the frame

Plate

Frame groove

(Fig.3)