In-Ceiling Front Projection Screen Evanesce Tension Series User’s Guide Rev.012710-JA info@elitescreeens.com info@elitescreens.
Important Safety and Warning Precautions Be sure to read this user guide before use and follow the procedures below. Please retain this manual for future reference. To avoid any damage, do not use in conjunction with any accessories not recommended by the manufacturer. Handle the device carefully during transportation to avoid damage. To ensure safe and reliable operation, direct connection to a properly grounded power source is advised.
Warning The screen’s Top Black Drop is already set to its maximum drop distance. There is NO extra black top drop in the roller. Please be aware of this as it will void the limitation of your warranty. Changes or modifications (except cutting the power cord for hardwire installation) to this unit not expressly approved by Elite Screens is prohibited and will void the warranty.
1. 5-12V Trigger: The built-in 5-12V trigger input for your new CineTension2 allows your screen to synchronize its drop and rise with the projector's power cycle. The screen drops when the projector powers up and retracts when the projector powers down. The 5-12 volt adaptor connects to your projectors trigger output via a separate cable that may or may not be provided by the projector manufacture.
4. In-wall RJ-45 Module: The RJ-45 module connects to a local wall switch for Up/Down control of your Evanesce electric projection screen. Please follow the picture diagram below for instructions on how to connect this accessory. Elite Screens In-Wall Switch Module ( ZIW-Module ) Ethernet (RJ45) network cable (not included) Local wall switch In-wall UP/DOWN switch module (ZIW-Module) Elite Electric/Motorized Screen Steps to attach Elite Screens Motorized Screen to your local wall switch 1.
2. 2. Mounting Parts 4-6 pcs 4-6 pcs 8 4 2 4 Please make sure all parts listed above are included. If any parts are missing please contact us right away. 3. 3. Assembling the top bracket (C) I. Insert the hex screw (B) through the bracket’s screw hole II. Secure and screw the hex screw (B) with the hex nut (A) III. Slide the top bracket (C) through the railing on top of the case 4. 4. Securing the Suspension Bar (D) I.
5. 5. Optional installation (parts not included) I. Place the top brackets (C) in the desired location on the screen’s housing and measure the distance between them as depicted on L. II. Mark the location of where the screen will be installed according to the L distance and then secure the screw bolt to the ceiling. III. Install the screen to the screw bolt as show in the figure below.
*Measurement dimensions are intended as a reference only and subject to change without notice.
ATTENTION: This adjustment is not required. The screens tension has been set to achieve its best performance. Always contact an Elite Screen Technician for assistance to avoid damaging the screen and voiding your warranty. Pulling the knob and turning it Clockwise it will create more tension to the screen. By pulling the knob Counter-clockwise it will start to release tension. If the electric screen does not move, please check the following: 1. Check the power supply first.
REMEMBER TO REGISTER YOUR WARRANTY AT WWW.ELITESCREENS.COM/REGISTER.HTM US & Canada Tech Support & Warranty Claim Please contact us at service@elitescreens.com or call +1 877-511-1211 #3 Service Europe Tech Support & Warranty Claim Please contact us at service@elitescreens.eu or call +49-(0) 40-30392958 Asia Tech Support & Warranty Claim Please contact us at service@elitescreens.com.cn or call +86-(0) 755-8461-7989 Taiwan Tech Support & Warranty Claim Please contact us at service@elitescreens.com.
10