User Guide

03/07/2016-ESA 4 www.elitescreens.com
9. Sand the surface until no adhesive residue remains.
10. Apply one coat of Professional R-35 Primer (do not allow it to dry) and immediately apply the Insta-DE2 to
the wall.
11. Unroll the Insta-DE2 on to the wall lining it up with the drawn line from Step 3.
Note 1: Each side of the material is labeled FRONT/BACK
Note 2: Do not allow the material to wrinkle or crease to avoid permanent damage.
12. Flatten the surface with a flexible wall smoothing tool in a 45-degree angle to avoid scratching the surface.
13. Lift edges and smoothen out any remaining air bubbles.
Caution
The smoothing tool’s edge is sharp. Carefully scrape the screen when removing air bubbles to avoid scratching
the surface.
14. Peel off the top layer of the double-sided tape and flatten the screen’s edges with the smoothing tool.
15. Use a soft damp towel or sponge to clean entire surface.
Tip
1. In rare instances, High indoor temperature will cause the surface to expand and produce bubbles.
2. Because the back of the Insta-DE 2 is very smooth, the glue does not easily stick to the wall by itself. For
this reason a coating of R-35 primer has to be applied to the wall.
3. Use a sharp utility knife to cut a small hole in the center of the bubble. Inject some Professional R-35 primer
with a syringe and smooth out the Insta-DE 2 screen surface with a smoothing tool.