User Guide

03/07/2016-ESA 5 www.elitescreens.com
Adhesive black velvet border installation
1. Measure the top/bottom and left/right sides of the Insta-DE2 screen to obtain the required length of the velvet
border you will need to use for bordering your screen.
2. Peel a small portion off of the velvet border and place it about half an inch over the white area of the screen.
Continue to peel off and roll out the remainder of the velvet border until you have reached the end and cut the
edge.
Note: For best results we recommend cutting the edge in a 45° angle.
3. Repeat the process for the remainder of the sides until all sides are bordered as shown below.
4. Allow the compound to dry for approximately 24-ours before using the dry-erase feature of the Insta-DE2.
Use only the included erasers to remove and erase dry-erase markings. For a deep clean, we recommend using
a non-alcohol based dry-erase board cleaner with a soft microfiber cloth.
Elite offers a replacement kit (part number ZER3) which includes:
1 x bottle of 8.45 oz cleaning solution
1 x microfiber cloth
2 x high density foam erasers
2 x sets of dry-erase markers (4 total)
Contact your reseller or visit shop.elitescreens.com for pricing and purchase.
Safety Precautions:
A. Avoid using sharp objects directly on the screen, which can result in permanently damaging the product and
voiding your warranty.
B. Creases or wrinkles caused by improper installation are not removable.