User Guide

www.elitescreens.com [e-mail]
SCREEN OPERATION
Note: Always pull the screen down or let it up in a 90-degree vertical angle. Do not allow the screen to touch
the screen case when the screen goes up or comes down to avoid damaging the screen material.
1. Pull the screen down from the lanyard or from the handle only in a 90-degree angle. Do not attempt to pull
the screen down by the surface or touch the screen, as it will damage the screen and void the warranty.
Note: An internal auto-lock mechanism system will cause the screen to stop and lock on the position at
intervals.
2. If you want to the screen to retract back, simply pull the screen down more than 2 inches and retract the
screen back by quickly and smoothly releasing it up gently.
Note: Always release at a 90-degree angle and do not let go until the screen is entirely inside the case
If ever the screen feels stuck, keep in mind that the screen’s mechanism is new and needs to be run up/down a
few times to loosen up. If this happens, carefully with a little force yank the screen straight down to unlock the
screen.
Note: Improperly bringing the screen up/down will damage the screen material or rolling system.
MAINTENANCE
Clean matte white screen material with a soft cloth and mild soap with water.
When not in use, retract screen in its housing to keep the screen material surface clean.
NOTE: Regardless of mounting method, the screen should be securely supported so that vibration or even
abusive pulling on the viewing surface will not cause the case to work loose or fall. The installer must insure
that the fasteners used are of adequate strength and suitable for the mounting surface chosen.