Projector User Manual

ManualsBrandsElite Screens ManualsProjectorM113NWS1-SRM

www.elitescreens.com

info@elitescreens.com

Note: Regardless of the mounting method, the screen should be securely supported so that

when retracted, deployed, or even abusive pulling on the screen, the case will not become loose

or fall. The installer must insure that the fasteners used are of adequate strength and suitable for

the installation location.

1. Carefully unpack the screen.

2. Always handle the screen in a leveled position on a clean surface.

Manual SRM Series

Manual Pull-down screen with built-in slow retract mechanism

User Guide

v.12

Pre-Installation

Summary of content (8 pages)

PAGE 1
User Guide Manual SRM Series Manual Pull-down screen with built-in slow retract mechanism Pre-Installation 1. Carefully unpack the screen. 2. Always handle the screen in a leveled position on a clean surface. Note: Regardless of the mounting method, the screen should be securely supported so that when retracted, deployed, or even abusive pulling on the screen, the case will not become loose or fall.
PAGE 2
Installation Flush Mount to the Wall 1. Mark the location of where the screen is to be installed for the pre-drilled hole. 2. After marking the area and drilling the hole, insert the proper screw into the drilled hole and leave about 1/8" of an inch from the wall to mount the screen. 3. Mount your screen from the keyhole located on back of screen’s left and right end cap. Back of end cap Front view Ceiling Mounting (additional hardware required) 1.
PAGE 3
Screen Operation & Maintenance Note: Always pull the screen down or let it up in a 90-degree vertical angle. Do not allow the screen to touch the screen case when the screen goes up or comes down to avoid damaging the screen material. 1. Pull the screen down from the lanyard or from the handle only in a 90-degree angle. Do not attempt to pull the screen down by the surface or touch the screen, as it will damage the screen and void the warranty.
PAGE 4
Dimension Table Model M85XWS1-SRM M99NWS1-SRM M113NWS1-SRM M84NWV-SRM M100NWV1-SRM M120XWV2-SRM Unit: mm Model M85XWS1-SRM M99NWS1-SRM M113NWS1-SRM M84NWV-SRM M100NWV1-SRM M120XWV2-SRM Unit: inch Nominal Diagonal & Aspect Ratio 85" (1:1) 99" (1:1) 113" (1:1) 84" (4:3) 100" (4:3) 120" (4:3) Case Length (A) 1677 1938 2192 1867 2192 2598 Screen Width (A1) 1603 1854 2106 1783 2108 2514 View Width (A2) 1527 1778 2030 1707 2032 2438 Weight Bar Length (A3) 1673 1934 2188 1863 2188 2594 Bottom Edge Distance (
PAGE 5
Warranty Policy • Two (2) Year parts and labor warranty from defects in workmanship from purchase date as follows (except for refurbished units as specified below). • Three (3) Year parts and labor warranty from defects in workmanship for GEMR (Government, Educational, Military, & Religious) purchases of new product only. • Refurbished Units carry a 90‐DAY parts and labor warranty. • Each party will be responsible for one way shipping during the warranty period.
PAGE 6
Contact Information US & Canada Tech Support & Warranty Claim Please contact us at service@elitescreens.com or call +1 877.511.1211 #3 or fax +1.562.926.8433 Europe Tech Support & Warranty Claim Please contact us at service@elitescreens.eu or call +49 (0) 40.30392958 Asia Tech Support & Warranty Claim Please contact us at service@elitescreens.com.cn or call +86 (0) 755.8461.7989 Taiwan Tech Support & Warranty Claim Please contact us at service@elitescreens.com.tw or call +866.2.8990.
PAGE 7
Notes www.elitescreens.com -7- info@elitescreens.
PAGE 8
www.elitescreens.com info@elitescreens.