Application Guide

Q8: How do I sync my RF remote to my Elite electric screen
A: If your RF remote control does not work with your screen, try the following to get in synced. See below for instructions.
Make sure new batteries or working batteries are in your RF remote control before proceeding with the steps.
For V 2.0 electric screens.
The version number can be found on the remote control, the sticker on the screen's end cap, or the packing box.
1. Unplug your screen from the power outlet
2. Hold the UP button on your RF remote
3. While holding the UP button, plug the screen back to the power outlet
4. Wait 5 seconds and then release the UP button
5. Now you can use your RF remote
For V 1.4-1 and below (ex 1.3, 1.4, 1.4-1)
1. Press & hold the Up button on your RF remote control so the LED light turns on
2. While holding the UP button on your RF remote, simultaneously push the small button located on the circuit board. In
some cases, you can press this button through a hole on the end cap. (Please note you may need a small sharp object to
achieve this.)
3. Continue to hold the UP button for an additional 3 seconds.
4. After 3 seconds, your RF remote should now by synced to control your screen.
Q9: I know that all Elite motorized screens include a built-in 5-12 volt trigger RJ45 input port, but what if my
projector does not have a 5-12 volt trigger ouput port. How can I take advantage of this feature on my Elite
screen and my projetor?
A: Elite Screens offers a wireless Universal 5-12 volt projector accessory (Part# ZU12V) for projectors that do not have a
trigger output. Contact your preferred Elite Screens reseller or visit shop.elitescreens.com for information about purchasing
this product.
Q10: My screen is receiving RF interference, is there a way to reset the circuit board?
A: Yes, version 2.0 screens have a reset button located on the circuit board which helps eliminate RF interference.
Please Click Here for instructions on how to locate the circuit board on your screen.
Q11: What voltage does the Universal Wireless 5-12 V Projector Trigger ZU12 support?
A: The Universal Wireless Trigger is compatible with voltages 90V – 240V.