User`s guide

ManualsBrandsElite Screens ManualsProjectorsQuickStand 5-Second

071614-ESA www.elitescreens.com 1

QuickStand 5-Second Series

Large Free-Standing Pull up Projection Screen

User’s Guide

Thank you for choosing the QuickStand 5-Second Series projection screen! Please read through this user

guide before utilizing the screen. Correct usage and maintenance will ensure a long product life

1. Dust, dirt and scratches on the projection surface will affect the picture quality, please take note of

the points below to prevent that from occurring:

 Do not touch the projection surface with your hands

 Do not write or draw on the projection surface

 Do not use fingers or sharp objects to point on the projection surface; this will damage the screen

material.

 Use a soft-damp cloth to clean the projection surface; do not use chemical cleaning agents or alcohol.

 Use clean water when dampening the cleaning cloth and do not rub against the material to clean it.

2. After using the screen, disassemble it and store it in the carrying bag provided.

3. To avoid damage and injury, the screen should only be operated by adults.

Product Description

Design: The QuickStand 5-Second Series allows a quick set up. The screen includes a built-in stage case for

travel. It pops out of the case and is extended using a dual-scissor support system.

When unpacking the screen, check that all parts are included

Parts List

A. Horizontal Support Bar x2

B. Vertical Support T-Bar x3

C. Drape x2

D. Top Cover Foot x2

Note: The parts list above is subject to change without notice.

Summary of content (4 pages)

PAGE 1
QuickStand 5-Second Series Large Free-Standing Pull up Projection Screen User’s Guide Thank you for choosing the QuickStand 5-Second Series projection screen! Please read through this user guide before utilizing the screen. Correct usage and maintenance will ensure a long product life 1.
PAGE 2
Opening the case 1. Begin by unlocking the four locks by turning them counter-clockwise. 2. Then open up the case making sure the left and right hinges are fully extended. 3. Install the Top Cover Foot (D) on the Left and Right side as shown below. 3 2 1 Drape Kit Installation 1. Once the case has been opened, you will find the Drape Kit inside the top cover. 2. Insert the Vertical Support T-Bar (B) into each slot inside the case. 1 2 3.
PAGE 3
How to Raise the QuickStand 5-Second screen Caution:   Two-man operation is required. Always pull and push evenly simultaneously on both scissors. Failure to do so will damage the screen and is not covered under warranty. Step 1. Grasp the lifting handles and raise the screen to the highest possible level. This will cause the (scissor-spring) supports to expand for step 2. 1 （图 5） Step 2.
PAGE 4
How to lower Quick Stage Screen Step 1: Grasping the lower spans of the (scissor) support, gently bring the screen down while maintaining the alignment of both supports. Step 2: Continue lowering while using a “hand-over-hand” method on the diagonal spans until the top handles can be reached. 1 2 Pull down a5 a6 b5 b6 and then pull down again a7 a8, b7 b8 Step 3: Ease material down until it is fully retracted and firmly bound around the roller. Close the casing lid and secure the locks.