User Guide

Rev.1/15/2016 4 www.elitescreens.com

B. Ceiling Mount

I. Flush Ceiling Mount (fixed position on end caps)

NOTE: The brackets do not slide. They are designed to attach the end caps only.

1. Attach the Wall/Ceiling mount bracket (A) to the Bracket connector (D) located on top of the screen’s housing (preinstalled).

2. Determine where the screen will be installed. Then, measure and mark the distance between the (WxH) locations.

3. Drill a hole on all marked areas and insert a dry-wall anchor(C).

4. Secure the screen by inserting the M4x50 screw (B)and a washer (I) thru thewall/ceiling mount brackets (A).

Two or more people are required while one holds the screen in place.

II. Suspended

1. Screw the eyebolt (G) on the bracket connector (D).

2. Attach the snap link (J) through the eyebolt (G) and connect it to an eyebolt screw (not included) rated

for the screen’s weight.

Saker Series | Controls and Accessories

A. IR Remote

B. RF Remote

C. Wall switch control box

D. 5-12 volt trigger cable

E. IR extended “eye” receiver

F. Wireless 5-12v trigger cable

G. AAA batteries

H. Bubble leveler

Dry-wall anchors (C)

M4x50 screw (B)

Ceiling

Washer (I)