User Guide

Rev.1/15/2016 6 www.elitescreens.com
UP
Stop
Down
For more information, technical support or your local Elite Screens
contact, please visit www.elitescreens.com
6. Wireless 5-12 volt trigger (Item F, Fig 5): The RF remote control serves as a dual purpose, independently as a
handheld remote control, or in conjunction with the Wireless 5-12 volt trigger cable. The radio frequency
technology can be programmed to send a wireless signal to synchronize its drop & rise with the projector’s power
cycle.
Here’s how to set up your Wireless 5-12 volt trigger | Synchronization Instructions
Step1: Connect the wireless 5-12 volt trigger cable to the RF remote (3.5mm)
Step 2: Connect the 12 v adaptor end of the wireless 5-12 volt trigger cable to your projector
Step 3: Make sure to unplug your screen from the power outlet
Step 4: Hold the UP button on your RF remote
Step 5: While holding the UP button, plug the screen back to the power outlet
Step 6: Wait 5 seconds and then release the UP button
Step 7: Your 5-12V wireless trigger should now be activated with your screen and ready to be used and able to
control your screen with your projector’s power cycle
Repeat the steps again if not successful.
(Please be aware, the projector on/off cycle may take longer to fully activate. It usually takes around 20-30
seconds for full off and on cycle each time)
DC 5-12V out
Wireless 5-12V
trigger cable
The back of the
projector
Fig 5