User Guide

051215-JA 4 www.elitescreens.com
B. Ceiling Mount
I. Flush Ceiling Mount (fixed position on end caps)
NOTE: The brackets do not slide. They are designed to attach the end caps only.
1. Attach the Wall/Ceiling mount bracket (A) to the Bracket connector (D) located on top of the screen’s housing (preinstalled).
2. Determine where the screen will be installed. Then, measure and mark the distance between the (WxH) locations.
3. Drill a hole on all marked areas and insert a dry-wall anchor(C).
4. Secure the screen by inserting the M4x50 screw (B) and a washer (I) through the wall/ceiling mount brackets (A).
Two or more people are required while one holds the screen in place.
II. Suspended
1. Screw the eyebolt (G) on the bracket connector (D).
2. Attach the snap link (J) thru the eyebolt (G) and connect it to an eyebolt screw (not included) rated for the screen’s
weight.
Screen material tension adjustment (4mm Allen Wrench required and not included)
Remove the weight bar end cap to expose the adjustment tension knob. Insert a 4mm Allen Wrench to push
in the adjustment tension knob, turn clockwise to gain more tension. Turn the Allen Wrench counter
clockwise and to lose tension. Please note this adjustment is not necessary as the tension of the screen has
been set to its factory setting for best performance. Please contact Elite Screens for assistance to avoid
damaging the screen and voiding your warranty at [e-mail]
H
W
Dry-wall anchors (C)
M4x50 screw (B)
Ceiling
Push
Tension knob
Washer (I)