User Manual

Table Of Contents

Rev. 051117 DR 0 www.elitescreens.com

Tripod Portable Projection Screen

Tripod Series / Tripod Pro Series

USER’S GUIDE

Tripod Screen Parts Identification

Using the Screen

A. Setting up the screen:

Follow the steps below and Fig. 1 & 2.

1. Place the screen in an upright position (fig.1) with the legs toward the ground.

2. Deploy the Tripod Support legs by pushing down on the Tripod Junction.

Top Hook, Keystone

Eliminator & Screen Handle

Vertical locking sleeve ring

Support beam

Vertical

Extension Bar

Screen Material

Screen case

Carrying handle & Screen height

adjustment lock/release tab

Tripod junction

Tripod Support Legs

End cap

PAGE 1
Tripod Portable Projection Screen Tripod Series / Tripod Pro Series USER’S GUIDE Tripod Screen Parts Identification Support beam Top Hook, Keystone Eliminator & Screen Handle Vertical Extension Bar Vertical locking sleeve ring Screen Material Carrying handle & Screen height adjustment lock/release tab End cap Tripod junction Screen case Tripod Support Legs Using the Screen A. Setting up the screen: Follow the steps below and Fig. 1 & 2. 1. Place the screen in an upright position (fig.
PAGE 2
3. Turn the tripod’s screen casing in a 90-degree horizontal position so that the screen casing is now parallel to the ground with the screen handle facing the bottom of the top hook. 4. Completely extend the legs as much as possible so they are stable and position them away from objects that may interfere with their balance. DO NOT stand the tripod on an unstable platform to avoid an injury should the tripod screen collapse. 1 3 Fig.1 2 4 Fig. 2 B.
PAGE 3
C. Disassembling the screen: Follow the steps below and Fig. 4. 1. Unlock the Adjustment Handle by pulling the locking tab to the left and slowly slide the handle all the way down to bring down the position of the screen’s case. 2. Hold the Extension Bar and twist the Vertical Locking Sleeve Ring counter-clockwise to unlock and release the position of the extension bar.