Instruction Manual

ManualsBrandsElite Screens ManualsMultimediaYard Master(Rear)

! ! 1!

Yard Master Series

Rear Projection Outdoor Movie Screen

User’s&Guide&

Note:

1. The Ring-Stakes, Curved-Stakes & Guy Rope should always be installed for Stability.

2. Use of this product is not recommended in gusty winds over 20mph.

Maintenance:

1. Soft cloth with mild soap &water may be used to clean the screen’s surface.

2. To prolong the lifespan of this product, store it in its carry case when not in use.

Parts&checklist&(Model:&OMS100HR/OMS120HR)& &

A.&Screen&material&x1&

B.&Steel&tube&x10&

C.&Fiber&glass&pole&x4&

D.&Carrying&bag&

E.&GuyNropes&x4&

F.&M6&hex&nuts&x2&

G.&Curved&stake&x4&

H.&Ring&stake&x4&

I.&M6x43mm&hex&screw&x2&

J.&Long&v e lcro &b a nd &x 20 N25pcs&

Length&30CM&

K． Button&band&x7N12pcs&

Length&30CM&

A. Main Support Metal Frame Assembly

1. Assemble the steel tube frame by connecting the letters on the ends of the tubes together as shown in

the picture. For example, A to A, B to B etc.

2. A and J are attached and secured with the provided Hexagonal Screws (G). This will be the last step.

Summary of content (5 pages)

PAGE 1
Yard Master Series Rear Projection Outdoor Movie Screen User’s Guide Note: 1. 2. The Ring-Stakes, Curved-Stakes & Guy Rope should always be installed for Stability. Use of this product is not recommended in gusty winds over 20mph. Maintenance: 1. Soft cloth with mild soap &water may be used to clean the screen’s surface. 2. To prolong the lifespan of this product, store it in its carry case when not in use. Parts checklist (Model: OMS100HR/OMS120HR) A.
PAGE 2
3. After the frame has been built, lay it on a clean scratch-free area. Step 2: Screen Material Frame Assembly (Fiber glass poles) 1. Join the Fiber Glass Pole to form a straight support rod as shown in the diagram below. 2. Repeat until all four rods have been formed; two vertical and two horizontal rods. Vertical Support Rod x 2 Horizontal Support Rod x2 Step 3: Attaching the screen material to the frame 1.
PAGE 3
2. Insert the vertical support rods into the left and right sleeves of the screen material. Vertical support rod Vertical support rod 3. Place the screen material (Elite Screens logo facing up) inside the metal frame. Front of Screen material 4.
PAGE 4
Step 4: Final assembly and support system set up 1. Stand the frame upright, and rotate the legs (A) and (J) 90 degrees and insert the hexagonal screws. Secure using the M6 hex nut (I) place. A Legs A and J are to be rotated 90 degrees. M6 hex nut M6hexagonal screw J 2.
PAGE 5
Warning Instructions 1. The Ring-Stake and Curved Stake should be properly driven into the ground to avoid the frame from falling which could result in injury or permanent damage to the screen. 2. Always be cautious of strong windy conditions. We don’t recommend using over 20mph. 3. A soft terry cloth with mild soap and water may be used to clean the screen surface. For a local Elite Screens contact or Technical Support, please visit www.elitescreens.