Owner's manual

Rev1204-12-JA www.elitescreens.com 1

ZPM-RT

Remote Control Kit for Spectrum2 Series

What’s included:

G. AAA Batteries

110”

A. B. Red+ Green -

IR Remote RF Remote C. 12V Trigger D. IR ey receiver

ZPM-RT Installation & Control Instructions1

1. Disconnect the 3 Way Control Switch from the Spectrum2 as shown below.

3 Way Control Switch

Screen

F. Wall box

PAGE 1
ZPM-RT Remote Control Kit for Spectrum2 Series What’s included: G. AAA Batteries 110” A. IR Remote B. RF Remote Red+ Green - C. 12V Trigger D. IR ey receiver F. Wall box ZPM-RT Installation & Control Instructions1 1. Disconnect the 3 Way Control Switch from the Spectrum2 as shown below. 3 Way Control Switch Screen Rev1204-12-JA www.elitescreens.
PAGE 2
. Connect the Wall Box (F) to the screen as shown below. Wall box (F) Screen ZPM-RT Installation & Control Instructions 2 Please consult a professonial installer for this procedure. Elite Screens is not responsible for faulty installations. 1. Cut the cable of both the Wall Box (H) and the attached Control Switch to expose the wires. Cut Cable Cut Cable Wall Box (H) 2. Connect the wires from the screen to the Wall box (H) according to their specific color.
PAGE 3
. The Wall Box (H) should be connected to your screen as shown below. Wall Box (G) 12 Volt Trigger (E) 1. Connect the 12 Volt Trigger (C) to the Wall Box (H) for set up to your projector. Wall Box (G) 12 Volt Trigger (E) Red Wire + DC12V Green Wire 0VConnect to Projector IR Eye Receiver (D) 1.