Specifications

13
STANDARD INSTALLATION LAYOUT
Sample Installation is Shown on Previous Page.
Caution: DO NOT allow
arms to scissor when open.
Mount bracket at least a quarter of the gate length from the gate hinge.
Arm must be 90° from Gate
Gate Hinge
Top View of Closed Gate
Output Shaft
Center
CSW200UL™ in
Open Position
Bracket Position
1/4
Bracket Length
Bracket
24"
Concrete Pad
28"
Arm
Arm
Important Note:
If this dimension is between
20 and 32 inches, “Compact
Installation” is necessary.
(Refer to next page)
Helpful Layout Note:
A) Tack weld bracket in position.
B) Close gate, place tape measure
between Bracket and Output Shaft.
C) With tape between bracket and
output shaft, open gate and bend
tape until tape is 90° from gate.
D) Take measurements of arms
from bent tape measure.
For technical support please call:
1-800-528-2806
1/4 1/4
Bracket Length Minus 8"
(Minimum)
Bracket Length
9"9" Minimum
for Gate
Clearance
Drawing not to scale
1
2
10"
Gate
Open 90°
Gate Hinge Center
Standard Installation Layout
8"8" Minimum to avoid
scissoring of arms
CSW200A Manual.qxd 12/9/04 3:11 PM Page 13