Specifications

21
CLUTCH ADJUSTMENT
MOUNTING REQUIRED WARNING SIGNS
Typical Clutch Slippage
(1/4 Turn)
Adjust the
Clutch with
a Wrench
Gate in Closed Position
Gate is Given an
“Open” Command
Before Completing
a Normal Close-Cycle
Gate Smoothly
Reverses Direction
with the Clutch Slipping
1/4 to 3/4 Turn
Gate in
Opened
Position
(Starting Position)
(Finishing Position)
The adjustment is for a gate that is over 300 pounds and 12 feet long or longer. While the gate is closing, instantly
an “open” command is given as shown above; the clutch may slip a bit, max. of 1/4 to 3/4 of a turn (slippage
depends on the weight of the gate). If it does not slip, then readjust the clutch.
Warning Signs Attached on Both Sides of Gate
Warning Sign Clearly Visible on Operator
Elite Part # A WS
Installers are required to adhere to this procedure: The UL required Warning Signs must be installed in plain
view and on both sides of each commercial gate installed. Each sign is made with fastening holes in each corner
and should be permanently secured in a suitable manner. Also the warning sticker should be placed on the
operator so it is clearly visible. Installers should keep photos of signs on gate in their records.
Clutch Adjustment
Mounting Required
Warning Signs
40-50399A
W
4
O
FF
O
N
CSW200A Manual.qxd 12/9/04 3:11 PM Page 21