Specifications

27
REMOVE CONTROL BOARD
AUDIO ALARM
The gate is too heavy or the arm is installed wrong (Refer to page 13 and 16).
1
Gate hinges are too tight or
broken and the gate is not
moving freely.
3
The gate hits the driveway, curb
or other, and gets stuck or bent
in an awkward position.
2
The gate is moving and a
vehicle pushes the gate.
5
A foreign object is on the gate
frame while the gate is moving.
4
When one of the following events happens Twice Consecutively,
the Alarm will Sound for 5 minutes!
W
4
W
4
O
F
F
O
N
O
F
F
O
N
Disconnect wire harnesses from OmniControl board. Unscrew 3 nuts and remove board.
Remove
Control Board
Audio Alarm
Press the Built-In Reset Button to Shut Off Alarm
and Reset Operator! (See previous page)
CSW200A Manual.qxd 12/9/04 3:11 PM Page 27