Specifications

CENTER SAFETY EXIT
CENTER SAFETY EXIT
FIRE
DEPT.
13
STRIKE
OPEN
RADIO
RECEIVER
TIMER
SYSTEM ON
EXIT
LOOP
ALARM
SENSOR
REVERSE
SENSOR
OPEN
STOPCLOSE
SAFETY
LOOP
CENTER
LOOP
GATE
LOCKED
60
POWER
OVERLOAD
OFF
W4
OPEN LEFT
DC-BACKUP
ALARMSENSOR
OPEN RIGHT
3
SENSORS
RESET
MOTOR
13
13
COMMAND
PROCESSED
ON
GB
MS LINK
A
MADE IN USA
OPTIONAL SAFETY PRECAUTIONS
UL Listed Edge Sensor
Secondary Entrapment Protection (Contact Sensor)
Edge Sensor Wiring
P
ALARMSENSOR
If you are going to use a contact sensor as a secondary entrapment protection you should use a recognized
component to comply with the revised UL 325 intended to be used in class I or class II gate operator.
Note: If multiple sensors are being used, all of the edge sensors are to
be connected in parallel at the Sensor Input on the OmniControl™ board.
Important: DO NOT remove any existing
attached wires from the Sensor/Alarm connector.
DangerDanger
When touched, these electrically
activated edge sensors
immediately signal the gate
operator to stop and reverse.
Property owners are
obligated to test edges
regularly.
Optional Safety Precautions
Secondary Entrapment Protection (Contact Sensor)
Op
t
ional
P
roduct
Part #s G65MGO20
G65MGR20
G65MGS20
46
CSW200A Manual.qxd 12/9/04 3:11 PM Page 46