Specifications

52
PROPERTY OWNERS CHECKLIST OF INSTALLATION
Property owner and Installer must read all warnings and safety precautions and be aware of
their roles and responsibilities. (Pages 4-11)
Make sure mounting pad is big enough and deep enough for operator. (Page 12-15)
Operator must be
securely fastened to concrete pad or mounting plate. (Page 12-15)
Operator arm must be
level and welded properly to gate. (Page 16)
Rectangular tubes on operator arm must be
completely welded around. (Page 16)
When gate is pulled,
No slippage of operator arm should occur. (Page 17)
Gate operator must be grounded to an earth ground rod within 3 feet. (Page 18)
Verify that the AC power is connected properly and
Property Owner knows how to shut off
power to operator. (Page 18)
Verify that the gate opens and closes as needed. (Page 20)
When gate hits object during operation, it
must stop or reverse. (Page 22)
Know how to operate the emergency release. (Page 29)
Make sure that any pinch point or potential entrapment are guarded by means of safety
devices or like. (Page 44-46)
Warning placards need to be permanently mounted on
both sides of gate. (Page 21)
Test all additional equipment connected to operator.
Make sure
all wire connections are securely fastened.
Review typical maintenance on operator. (Page 51)
Schedule periodic maintenance on operator by qualified service technician.
Inquire about Manufacturers
“operator warranty”. (Warranty Card Included with operator)
Inquire about
separate “installation warranty” with installer.
2.
3.
4.
5.
6.
7.
8.
1.
13.
14.
15.
16.
17.
18.
19.
9.
10.
11.
12.
Property Owners Checklist of Installation
CSW200A Manual.qxd 12/9/04 3:11 PM Page 52