Use and Care Manual
PARTS INDICATOR
To Assemble
1. Before using the product for the first time, wash all the parts except the Motor
Housing in warm, soapy water, and then rinse and dry thoroughly.
CAUTION: Never immerse the Motor Housing in water or other liquids. Never use
abrasive cleaners on any part of the product. Do not place any parts into a
dishwasher or extremely hot water.
2. Place the Motor Housing on a flat, stable surface, and then place the assembled
Glass jar in the top of the Motor Housing and turn counterclockwise until it is firmly in
place.
3. Place the Lid with Cap onto the Glass jar.
HOW TO USE
CAUTION: Do not operate the product until it is properly assembled.
1. Ensure the product is unplugged from the electrical outlet.
2. Pour liquid ingredients into the glass jar.
3. Wash all solid ingredients and cut them into pieces small enough to fit into the Cap.
CAUTION: The glass jar has a six cup (48 oz. /1.5 liter) capacity. Do not over-fill it.
CAUTION: Do not use the product for mashing or grinding heavy foods (e.g., potatoes or
meats) or to stir thick mixtures (e.g., dough).
4. After filling the glass jar with ingredients, place the Lid with Cap securely onto the jar.
5. Plug the product into a standard 110-120 volt AC electrical outlet.
6. Select the desired speed setting.
- Press HI or LO to select upper or lower speed selections.
TIP: If the Blades are not operating smoothly, stop the machine and add some liquid, stir
the contents or reduce the contents in the jar.
7. To turn off the product, press the “OFF” Button.
8. Always wait for the blades to completely stop before removing the glass jar.
9. Lift jar up and away from the main blender base.
10. Remove the cover and pour.
WARNING: Always unplug the product when it is not in use or will be left unattended.
CAUTION: Never operate the product empty.
CAUTION: Never operate the product’s motor for more than three minutes at a time.
Allow the motor to cool for 60 seconds after three minutes of operation.
1. Cap
2. Lid
3. Glass Jar
4. Gasket
5. Blade Assembly
6. Motor Housing
7. 10-Speed Panel
Control