Use and Care Manual

PREPARING YOUR PRESSURE COOKER (CONT).
4. Closing the Lid: Make sure the Rubber Seal Ring (18) is fitted properly onto the inner
part of the lid (2). Observe the Rubber Seal Ring (18) inside the lid (2) and ensure
that it is evenly fitted onto the track. (Caution: If the rubber seal ring is damaged, do
not use the pressure cooker. Contact Customer Service to repair or replace.)
5. Lift the lid (2) from the rested position. Close the lid (2). Hold the handle (1) and
turn it Counter-Clockwise to the “LOCKED” position. (A clamping sound can be
heard; See Figures 16-18).
Note: To ensure you are properly closing the lid (2), please make sure the pressure limiting
valve (3) is on your left side when you are facing the front of the pressure cooker (when
facing the control panel (10).
6. Adjust the Pressure Limiting Valve (3) to the “Air Tight” position , and ensure that
the Float Valve (5) sinks.
7. When adjusting the Pressure Limiting Valve (3) to either the "Airtight" or the
"Exhaust" positions, line up the marking on the Pressure Limiting
Valve (3) with the arrow on the Handle (1) as shown in Figures 19 and 20.
16
17
18
CLOSE
CLOSE
CLOSE
19
20
www.maxi-matic.com
12
[e-mail]