Instructions / Assembly

CEILING FAN LIGHT KIT
INSTALLATION AND SAFETY INSTRUCTIONS
To ensure a successful installation be sure to read these instructions and review
the diagrams thoroughly before beginning. Follow the instructions that are
applicable for your light kit.
Ceiling fan light kits are only meant to be used with ceiling fans. Do not install
as a light fixture.
Caution – Risk of electrical shock. Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse at the fuse box.
Turning the power off using the fan switch is not sufficient to avoid electrical
Review the installation instructions supplied with your fan. Make sure that your fan
has been wired properly into the ceiling to allow use with light kit.
All electrical connections must be in accordance with local codes, ordinances,
and national electric codes. If you
are unfamiliar with methods of installing
electrical wiring, secure the services of a qualified electrician.
1-glass shade
1-fitter with socket assembled
1-plastic bag containing:
- 4 shade screws (1 for spare)
- pull chain
- lock washer
- screw nut
- 3 wire connectors
PARTS
GENERAL
1-LED bulb
There are 2 different types of installations described below. Please read each one
carefully to determine the best method for installing your light kit.
Key Hole Installation
The key hole refers to slots in the light kit adapter in which screws mounted to the
bottom of the switch housing are inserted into these holes (See figures 1).
The adapter is then turned, locking the screws, and the screws are tightened.
Please refer to the Installation Instructions titled Key Hole Installation.
Universal Installation – Center Nipple Attachment
The universal installation usually works on all fans. This method uses the switch
housing cap on the fan and an outer threaded tube to mount the light kit (See
figure 2). Please refer to the Installation Instructions titled Universal Installation.
OVERVIEW
Hex Nut
Star Washer
Bushing
Fitter
Switch
Threaded Tube
Figure 3
If light kit does not work, turn off electricity and lower either canopy or decorative housing
on your ceiling fan to make sure the blue wire is connected to black household wire.
Please refer to electrical section on ceiling fan instruction manual.
1. If you want to replace the fitter for the fan
light kit, please loosen the hex nut and
bushing to release the fitter (See figure 3).
2. When
re-installing, please place the fitter ,
star washer over the threaded tube, then
tighten with hex nut. Take the switch through
th
e side hole of t he fitter then tighten with
the bushing.
NOTE: For the white and brushed nickel finish
fitters, please use the brushed nickel finish
hardware; For the oil rubbed bronze fitter,
please use the antique brass finish hardware.
TROUBLESHOOTING
REPLACE FITTER INSTALLATION
Questions, problems, missing parts?
Please call at toll free 1-888-722-5089
Monday - Friday 9:00 a.m. - 5:00 p.m. CST
Or mail: 507 Lindgren Ln, Belvidere, IL 61008, USA
East-West Commerce Co., Inc. / Elite
All rights reserved. Made in China
Model No.: LK1901