User Guide

DIGITAL EFX
16 DIGITAL EFX PROGRAMS
•
• There are 16 total Digital EFX programs
• R1 to R10 - REVERB
• E1 and E2 - ECHO
• ER1 and ER2 - Echo and Reverb
• CHO - Chorus
• FLange - Flanger
•
• Program select Encoder (11) is for pro-
gram change.
• Parameter knob (10) to change rate or
delay time for the program that is set.
• Mix knob (9) is to ne turn the amount of
EFX you want in output mix.
• EFX can be bypassed by Pressing the
bypass switch (12)
• EFX send levels for each channel is set
by on the rear panel ( 16 and 32, 38) that
correspond to each channel.
•
TIPS
• Distorted Sound
• 1) Check input level to make sure input Signal Light is in GREEN and not CLIP-
PING RED. Reduce Input by turn down GAIN knob (14, 30, 37). Make sure all
EQ knobs are set to Middle. (FLAT)
• 2) Check Monitor Signal Light is also GREEN and not Clipping. Reduce Speaker
Level by turning Monitor Knob (3), make sure EQ is set to middle (FLAT)
•
• No Sound
• 1) Check LED signal lights. Green means there is Signal on the input.
• 2) Make sure MIX knob is at 12 o’clock position.
• 3) Make sure Channel is un-muted.
• 4) Make sure +48V is on when using a Condenser Mic. Make sure to MUTE
when turning on +48V to prevent loud POP sound.
•
• Battery not Holding Charging
• 1) Power unit off and charge the unit for 6 hours with Battery switch in Connected
position. If problem still persist, contact [e-mail] for battery
replacement instructions.
•
•
•