Specifications

4
Vertical Size Adjustment
-2
-1
1st FAC
Start
or
Green screen
F1
ADJUST V SIZE
91% ± 2%
INPUT TV
General
broadcasting
Adjust the size so that the picture is completely
displayed on the screen.
4
Size Mode
4
Screen Size Adjustment
INPUT 1:Monoscope
Note :
Screen mode : FULL
-128 to 127
(even data only)
or
1st FAC
Start
Telop: White
Data value
Size mode
ADJUT H SIZE
a
Data value
a
b
F1 -24
Check if both vertical and horizontal sizes are within 91% ±2%. If they are not, perform the size adjustment as follows:
ANT
2
ANT
• Mode for roughly adjusting the
horizontal and vertical sizes of the
main deflection.
• In this mode, the color is green only,
screen size is FULL and the contrast
is +10.
• The above settings are cleared when
this mode is exited.
VOL
VOL
Picture Quality Mode H SIZE V SIZE
FULL A B
HD A+C B+I
1 : H SIZE (15K) Approx. -36 ± 30
2 : V SIZE Approx. +01 ± 10
6 : H SIZE (HD) Approx. +27 ± 30
7 : V SIZE (HD) Approx. +06 ± 10
: V Size
: H Size (15 kHz)
Size mode
b
1
7
1
2
: H SIZE (HD)
(fixed value "C" can be
varied)
6
: V SIZE (HD)
(fixed value "I" can be
varied)
7
6
2
A, B : Adjustment values
C, I : Fixed values
A+C : Addition of A and C
B+I : Addition of B and I
or
CH +
CH –
: H PHA (31kHz)
: H PHA (33kHz)
: H PHA (33K RGB)
: H PHA (31K RGB)
: H PHA (15K)
CH
3
9
0
0
3
9
Table on H SIZE and V SIZE data
Note: Varies depending on the factory-preset value.
The factory-preset values are as follows:
• Perform the H SIZE and V SIZE adjustments only in FULL
mode (NTSC MONOSCOPE signal input).
• Release the FACTORY mode, then change the screen mode
and confirm that the picture is not missing.
Key No.
Note :
Screen mode : FULL
Note :
• The adjustment is unnecessory for "C" and "I" so that is
set in factory shipment by the most suitable value.
However, please adjust it when a screen is missed when
displayed the HD source on the screen.
• For H PHA, refer to the section "• Reference."
Adjustment
Value
45.