Owner`s manual

10
system will indicate this condition to you by causing the
SYSTEM STATUS
button to light. When you press this
button, the system responds with, Sensor # Name tam-
pered. Correct the problem by resetting the sensor. If this
condition continues, call your security system dealer.
Siren 1 or 2 Failure
Call your security system dealer.
System Access Alarm
The panel cover was opened while the system was armed.
The system will call the central monitoring station to
report a tamper alarm.
Testing
Testing Sensors
You can test sensors one at a time to make sure they are
sending strong signals to the panel.
To perform the sensor test:
1. Open the panel Cover.
2. Enter the master access code.
3. Press the
Test
button once. The panel will announce
Sensor Test.
4. Press the
DONE
button.
The panel will voice prompt you with a list of your pro-
grammed sensors that you need to test. The panel will start
with sensor 1 and announce Test sensor 1, sensor name.
When you trip a sensor and it communicates successfully
it will be removed from the list. You may trip the sensors
in any order. The sensor test has a 4 minute time-out that
resets with each sensor trip.
After all sensors have been successfully tested, the panel
will announce Sensor test complete, press DONE.
Press
DONE
. The panel will announce Sensor test ok.
If any of the sensors did not test successfully and you want
to terminate the test,
press DONE or Cancel
. The panel
will announce Sensor test canceled or failure. If a sensor
test fails, call your security dealer.
Use the following table to trip devices:
Testing Communication
To perform a phone test:
1. Open the panel cover.
2. Enter the master access code.
3. Press the
Test
button twice. The panel will announce
Phone test, press again to change or done to select.
4. Press the
DONE
button.
The panel will announce Phone test is on twice. If the test
is successful the panel will announce Phone test ok within
3 minutes. If the test is unsuccessful, the
SYSTEM STA-
TUS
button will light and within 10 minutes the panel will
announce Phone communication failure. If a phone test
fails, call your security system dealer.
Note
If your system is not connected to a central monitor-
ing station, you won’t be able to perform the phone
test.
Setting the Clock
If the panel loses power, the clock must be set. The default
setting is 12 hour mode.
1. Open the panel cover. Panel announces, Use num-
bered keys to enter ID.
2. Enter the master access code. Panel announces,
Please select from Start Menu.
3. Press
Clock Set
from the Start Menu. Panel
announces, Time is ****, to change press hours and
minutes, then press done.
Clearing System Status
Press the SYSTEM STATUS button, listen to the status
message, then disarm the system to clear system sta-
tus. If the trouble condition was a low CPU battery, per-
form a sensor test. The SYSTEM STATUS button
should turn off if all trouble conditions have been cor-
rected.
Testing Sensors
Device Do This
Door/Window
Sensor
Open the secured door or window.
Motion Sensor Avoid the Motion Sensor’s view for 5
minutes, then enter its view.
Shock Sensor Tap the glass twice, away from the
sensor. Wait at least 30 seconds before
testing again.
Smoke Sensor Press and hold the test button until the
system sounds transmission beeps.
Wireless Panic
Button Pendant
Press and hold the appropriate panic
button(s) for 3 seconds.
Keychain
Touchpad
Press and hold LOCK and UNLOCK
simultaneously for 3 seconds.
Remote
Handheld
Touchpad
Press and hold the 2 EMERGENCY
buttons simultaneously for 3 seconds.