Owner`s manual

3
HOME CONTROL
The Home Control buttons are used to monitor activity
within and around the home. They are not used for intru-
sion protection. If any of the Home Control buttons are
pressed and a sensor or module is not associated (pro-
grammed) with this feature the panel will announce, Func-
tion not available.
Chime Doors
Chime Doors is used to signal the panel (chime) when a
protected door is opened while the system is disarmed.
The panel will chime twice and announce (see Option 41)
the door that has been tripped. This is a nice feature to use
if you’re busy in one part of your home and you want to
know when family members are going in and out of your
home.
Turn Chime Doors on:
1. System must be disarmed. Press
Chime Doors
button
.
Panel will announce Chime on. Chime Doors
button will
be lit.
Turn Chime Doors off:
1. Press
Chime Doors
button
Panel will announce, Chime off. Chime Doors
button no
longer lit
Chime Special Motion
This is used to detect movement within a specific area.
These Motion Sensors are not used for intrusion protec-
tion. The panel will chime three times and announce (see
Option 41) the sensor that has been tripped. Use the same
panel procedures as
Chime Doors,
except, with the
Chime Special Motion
button.
If you have Motion Sensors located in areas such as in a
patio area or at the front door and you want to know when
someone is approaching these areas, you would use this
feature.
Silent Exit
This feature silences the status beeps that accompany the
exit delay (see Status Beeps). Press
Chime Doors
after
you arm the system to silence status beeps. The panel will
still beep at the beginning and end of the exit delay.
EMERGENCY
Press
FIRE, POLICE,
or
AUX
for 2 seconds (or press
twice quickly) to call the central monitoring station and
notify them of a non-medical call for help.
How Your System Communicates
to You
Your system responds to you through the use of panel
voice messages, status beeps, alarms, and panel indicator
lights.
Panel Voice Messages
When you press the buttons on the panel or the touchpads,
the panel responds with voice messages. Panel voice can
be enabled or disabled (see “Options”).
These messages may respond with system information or
prompt you to take further action. For example, if you
want to disarm the system and you press the
DISARM
button, the panel responds by announcing, “Please enter
your access code.”
If you press a button and the feature has not been pro-
grammed, the panel voice will respond with “Function not
available.” An example of this would be pressing
CHIME Special Motion
button when you have no motion
sensors in your system.
Status Beeps
Status beeps are used to indicate key presses, status, and
problems with the system. They can be enabled or disabled
(see “Options”). The following table describes status beep
activity.
Note
You may receive a different number of status beeps if
buttons are pressed quickly.
oors Time
On
Sensor
HOME CONTROL
Lights
Chime
Off
Motion
Special
Status Beeps
Activity Beep Response
ARM
Doors &
Windows
Exit delay
and
Entry delay
beeps sound 2
times every 5 seconds and 2 times per
second during the last 10 seconds (if Silent
Exit is used, the Exit delay beeps will only
sound twice when you arm and twice when
the Exit delay expires)
ARM
Motion
Sensors
Exit delay
and
Entry delay
beeps sound 3
times every 5 seconds and 3 times per
second during the last 10 seconds (if Silent
Exit is used, the Exit delay beeps will only
sound 3 times when you arm and 3 times
when the Exit delay expires)
EMERGENCY
AUX
POLICE
FIRE