User Manual
Table Of Contents
- Conventions of This Manual
- Safety Precautions
- Wichtige Sicherheitshinweise
- Things you must remember before working on your computer
- Let your computer acclimate itself
- Heat, Cold, Humidity, and Glare
- Suitable place to work
- Preparing your Computer
- Knowing your Computer
- Bottom View
- Connecting to a Power Source
- Turning On Your Notebook Computer
- Operating on Battery Power
- Installing and Removing the Battery Pack
- Charging the Battery Pack
- Adjusting the LCD Screen Display
- The Notebook’s Hot Key Controls
- The TouchPad
- Power Saving Modes
- Removing the Battery Pack
- Resetting the System
- Adjusting the Brightness
- Using the Windows
- Control Panel
- Using a modem for Connection to Internet (optional)
- Using a wired LAN for Connection to Internet
- Using Wireless LAN Network for Connection to Internet
- Bluetooth Connection
- Entering the BIOS Setup Screen
- Leaving the BIOS Setup Screen
- BIOS Action Keys
- Modifying the BIOS Settings
- Audio Problems
- Hard Disk Problems
- Display Problems
- Keyboard and Mouse Problems
- CMOS Battery Problem
- Memory Problems
- PC Card Problems
- Performance Problems
- USB2.0 Problems
ii
¾ Reorient or relocate the receiving antenna
¾ Increase the separation between the equipment and receiver
¾ Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
Consult the dealer or an experienced radio TV technician for help
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void the
user's authority to operate this equipment.
Notice:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment. Shielded interface cables and a non-
shielded AC power cord must be used in order to comply with
emission limits.
This equipment is to be used with power supply:
40W
There is no internal power supply.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. End users must follow the
specific operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.