User's Manual Part 1

Warning! Any changes or modifications made to the equipment which are not

expressly approved by the relevant standards authority could void your

authority to operate the equipment.

Waste disposal instruction

Do not throw this electronic device into the trash can when discarding.

To minimize pollution and ensure utmost protection of the global environment,

please recycle it in European WEEE (waste electrical and electronic

equipment) directive system or recycle system in Taiwan.

iii

ECS SI mPC

MPE 䆖

䃎

ǆƉŽƐƵƌĞƚŽZĂĚŝŽ&ƌĞƋƵĞŶĐǇZĂĚŝĂƟŽŶ

To comply with FCC RF exposure compliance requirements, a separation distance of at least 20cm must be

maintained between the antenna of this device and all persons. This device must not be co-located or operating

conjunction with any other antenna or transmitter.

CE, FCC, NCC RF 䆖䃎

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un environnement non

contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source de

rayonnement et votre corps.

本產品符合低功率電波輻射性管理辦法第十二條、第十四條等條文規定

1. 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原

設計之特性及功能。

2. 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干

擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、

科學及醫療用電波輻射性電機設備之干擾。

䴫⻱⌒ᴍ䵢䟿MPE⁉Ⓠ٬1mW/cm ˈ䘱⑜⭒૱ሖ⑜٬⛪˖0.0941mW/cm

2 2

Edition 1Part No.

Printed in China OCT 2015

Japan VCCI Statement

CE mark. Declaring compliance to all the applicable European Union (EU) Directives.

Any special accessories needed for compliance must be specified in the instruction manual. Use only

shielded and terminated cables to connect I/O devices to this equipment.