User's Manual Part 2

This page sets up some parameters for system power management operation.

Power Management Setup

Advanced

Power Management Setup

Resume from LAN [Enabled]

Resume By PME [Disabled]

Resume By USB [Enabled]

Resume By RTC Alarm [Disabled]

EUP Function [Enabled]

Resume from LAN1 Help

Enter: Select

+/-: Change Opt.

F1: General Help

F2: Previous Values

F3: Optimized Defaults

F4: Save & Exit

ESC: Exit

: Select Screen

: Select Item

Use this item to enable or disable resume from LAN.

Resume from LAN (Enabled)

The system can be turned off with a software command. If you enable this item, the system can

automatically resume if there is an incoming call on the PCI/PCI-E Modem or PCI/PCI-E LAN card.

You must use an ATX power supply in order to use this feature. Use this item to do wake-up action

if inserting the PCI/PCI-E card.

Resume By PME (Disabled)

This item allows you to enable or disable the USB device wakeup function from S3 mode.

Resume By USB (Enabled)

The system can be turned off with a software command. If you enable this item, the system can

automatically resume at a fixed time based on the system’s RTC (realtime clock). Use the item below

this one to set the date and time of the wake-up alarm. You must use an ATX power supply in order

to use this feature.

Resume By RTC Alarm (Disabled)

This item allows you to enable or disable EUP function.

EUP Function (Enabled)

Press <Esc> to return to the Advanced Menu page.

ECS SI mPC